From your previous posts it seems you have the correct firmware (2v08) so there's no need to update with NRF Connect. Just to put everything in one place, you need to:
Long-press BTN1 + BTN2 for about 6 seconds until the screen goes blank
Release BTN2 but keep pressing BTN1 while ==== goes across the screen
Keep holding BTN1 while Bangle.js boots
Release it - you should have the Bangle.js logo, version, and MAC address
Now reset all the software by:
Opening https://banglejs.com/apps/ on a device with a web browser that can use Bluetooth (your PC may work but an Android phone with Chrome is an easy option here)
Click About in the top right
Click Install Default Apps
Click Yes
Choose the Bangle from the pop-up menu of devices and click Pair
Wait for the progress bars in the bottom of the webpage to finish - don't close the page or turn your phone/PC off while it's updating
When it's all done, long-press BTN3 to load everything up
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Hi! Which instructions were you following here?
From your previous posts it seems you have the correct firmware (2v08) so there's no need to update with NRF Connect. Just to put everything in one place, you need to:
BTN1
+BTN2
for about 6 seconds until the screen goes blankBTN2
but keep pressing BTN1 while====
goes across the screenBTN1
while Bangle.js bootsNow reset all the software by:
About
in the top rightInstall Default Apps
Yes
Pair
And it should all work great