You are reading a single comment by @user115873 and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@user115873
Hey there!
So I have a Puck.js v2, and I followed https://www.espruino.com/Puck.js#serial-console to hook it up to an FT232R -- Pin 28 to RX, Pin 29 to TX, set VCC to 3.3V, ran to 3v, and ground to ground.
The puck fires up, but refuses to talk via Serial1.
If I go in to the IDE via BT, Serial1.available() reports 0.
Serial1.setConsole(true) just makes it not respond via BT any more, and doesn't get the wired serial side working.
Any ideas?