Adjusting variables when building custom firmware

You are reading a single comment by @parasquid and its replies. Click here to read the full conversation.

•

Gordon

Ahh - can you check "Modules uploaded as functions" is checked under communication settings, and that you're definitely uploading to flash?

I just uploaded your code to a Pixl here and it went fine (up to the point that I2C failed because I didn't have an MPU6050 attached) with only ~900 vars used.

•

parasquid in reply to @Gordon

Ah I was uploading to RAM. Uploading to flash works :) (I didn't upload to flash because I had to reset the Pixl when the memory issues came up during upload)

And yeah, modules uploaded as functions is checked.

The module seems to be working, and is quite performant :) Thanks again for the help!

About

Avatar for parasquid @parasquid started