You are reading a single comment by @Sn3akyP3t3 and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Sn3akyP3t3
I was thinking I'll try out a PETG based filament for this job since it has excellent mechanical strength, doesn't warp under ranging temps, has a much higher melting point that PLA or ABS so if I accidentally leave it in the car it has a better chance of coming out not warped, and its food safe so I shouldn't worry much about constant contact with skin and leaching chemicals. Thanks for the tip though.