You are reading a single comment by @DBovey and its replies. Click here to read the full conversation.
  • Update: Problem partially solved! The "save" code at the end was the culprit, I commented it out and it seems to store the code on flash. Does the IDE have a setting for that?
    BUT: after saving, the BT link is gone. I cannot connect any more to the Pixl-multi, unless I erase the project code from it. Actually if I switch the device on (with the application code) while trying to connect, the communication link is visible for a couple seconds, then no more.

About

Avatar for DBovey @DBovey started