These are the results I have obtained with the new firmware (checked several times):
With the TELO 580 paired, I remove the battery from the Puck-js until the bluetooth icon of the TELO 580 indicates that no device is connected. I wait about 10 seconds with the Puck-js battery removed. Then I put the battery back (Red LED lights once) but the program does not start.
In some test, after a few seconds, the program has returned to work without doing anything. However, if I turn off the bluetooth of the TELO 580 and turn it on again, it automatically connects to the Puck.js and the program works again without having to execute the load () in the WebIDE.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
These are the results I have obtained with the new firmware (checked several times):
With the TELO 580 paired, I remove the battery from the Puck-js until the bluetooth icon of the TELO 580 indicates that no device is connected. I wait about 10 seconds with the Puck-js battery removed. Then I put the battery back (Red LED lights once) but the program does not start.
In some test, after a few seconds, the program has returned to work without doing anything. However, if I turn off the bluetooth of the TELO 580 and turn it on again, it automatically connects to the Puck.js and the program works again without having to execute the
load ()
in the WebIDE.