Hello @Grzegorz_
'Before the upgrade it was working fine'
For how long was it working?
What version of Espruino were you at, and what version were you attempting to flash (2v0 ? ) ?
Have you tried powering down the WiFi then reconnecting? Have you tried closing the IDE and relaunching?
Worst case, have you attempted to re-flash back to an older version from:
https://www.espruino.com/binaries/
or 'Find a binary'
http://www.espruino.com/Download#flashing
and what were the results of performing that task?
May I ask what PC O/S? Mac/Win10/Linux
What baud rate is the serial port set to? IDE >> Settings >> Communications
Is there any additional detail listed in the console output? IDE >> Settings >> Console towards the end of the listing
@Robin started
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Hello @Grzegorz_
For how long was it working?
What version of Espruino were you at, and what version were you attempting to flash (2v0 ? ) ?
Have you tried powering down the WiFi then reconnecting? Have you tried closing the IDE and relaunching?
Worst case, have you attempted to re-flash back to an older version from:
or 'Find a binary'
and what were the results of performing that task?
May I ask what PC O/S? Mac/Win10/Linux
What baud rate is the serial port set to? IDE >> Settings >> Communications
Is there any additional detail listed in the console output? IDE >> Settings >> Console towards the end of the listing