You are reading a single comment by @Dan.js and its replies. Click here to read the full conversation.
  • Looks great!

    I notice in a previous post's pic that the battery did not fit into the induction charger coil.... but obviously puck fits. So the lipo is now under the coil and puck?

    Next to the lipo, is there not some space left where you could place your additional electronics? ...may be on a different board...

    No matter what, it turned out great!

  • The previous photo doesnt have the battery in it. When I open up the case again Ill take another pic. The layout inside goes, coil with puck fitting perfectly in the middle, button circuit board with n2222 transistor for the motor and 78l33 voltage regulator on the right side, adafruit trinket lipo backpack, lipo on top of the puck then the screen.

About

Avatar for Dan.js @Dan.js started