Re-enable JTAG pins

Hello,

I have been programming an ESP32 with the IDF and able to use JTAG debugging without a problem.

When using Espruino however, the JTAG pins are configured for GPIO. Does anyone knows a way to set those back for JTAG?

We are talking about GPIO12-13-14-15.

How do you set up for jtag programming when you are using the ide-directly?

You might need to write a custom function to re-enable or define these pin modes - both would need custom firmware.

Just curious - why do need to debug at this lower level if you are using espruino?

Hi Wilberforce,

How do you set up for jtag programming when you are using the ide-directly?

I am not using the IDE. My test was to have a program running (blinky...) and debug it using JTAG (openocd).

You might need to write a custom function to re-enable or define these pin modes - both would need custom firmware.

OK, that´s what I thought. Thanks for confirming.

Just curious - why do need to debug at this lower level if you are using espruino?

Out of pure curiosity and since I got a JTAG debugger, I need to debug everything :)
My curiosity also pushes me to learn how YOU debug while developing Espruino itself but you may have already wrote about that (I did not search yet).