You are reading a single comment by @Gordon and its replies. Click here to read the full conversation.
  • If you're on 1v92 I don't think there's too much you can do. That firmware should have increased the IR output power as much as it can already. It's odd because when I was trying it with a normal IR receiver I was getting almost 2m with the new firmware I think.

    You could try it with the silicone case off? That could make a big difference. If that helps then you could potentially put a small hole in the case above the IR diode.

    There's also aiming to think about - with the case off, I seem to recall it emits to around 60 degrees - so if the Puck was on it's back you'd get far worse range than if it was pointing at your fan.

About

Avatar for Gordon @Gordon started