You are reading a single comment by @hungryforcodes and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@hungryforcodes
Weirdly I tried this on an ESP8266 -- and first the uploaded code was the same size as the IDE code (suggesting it hadn't been minified -- as its usually much smaller by almost 1/3), and then at one point during the upload the board just freaked out with an out of memory error and then a continuous stream of "Execution Interrupted", until the upload failed due to the "Prompt not detected error...".
Under communications I had selected upload modules as functions, and then after "Save On Send" was set to "Yes". And under Minification I have both modules and regular code set to simple optimizations using Closure.
The board was flashed with a standard v92, using the last official release.