You are reading a single comment by @Robin and its replies. Click here to read the full conversation.
  • Hey,
    I've tried a lot of times, everything I found online and what you told me to do.
    nothing works.
    I hooked up a usb-ttl converter and tried reflashing the firmware, but no luck
    same thing with starting bootloader mode; I pressed and held BTN1, then pressed and released RST, but nothing happens.
    The red and blue LEDs just glow dimly, and there's nothing I can do.

  • Sun 2017.03.05

    @user73202

    I've tried a lot of times, everything I found online and what you told me to do. nothing works.

    What is meant by "I've tried a lot of times" . . . . "what you told me to do"?

    Are you referring to the process of re-flashing or the removal of solder from the bridged solder pads?

    Has the solder bridge been removed?

    Is it possible that the correct BTN1 is being pressed and held with a tap on RST, but incorrect orientation may have them reversed? http://www.espruino.com/EspruinoBoard

    Do the Blu and Red LEDs flash at all after the release of RST? http://www.espruino.com/Troubleshooting

About

Avatar for Robin @Robin started