You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
-
The red and blue LEDs are dimly lit, so I think my board is stuck in some sort of "permanent reset." I also did a bit more research and found out that the bridged pins are the PCM_CLK and PCM_OUT pins on the HC-05. I don't know what these are, but I think they are the ones causing the bricking. However, if that's true, my board should've stopped working right after soldering the bt module.
BootySnorkeler
@Gordon
Personally I'd hold off anything until you get some solder wick - it might be you can fix it quite easily by removing those shorts.
Do any LEDs come on at all? If they don't it's likely because the 3.3v and GND lines are shorted (you could test with a meter)