You are reading a single comment by @Wilberforce and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Wilberforce
Are you using the code above?
Keep the code the same, and you need the wiring to the pins:
GPIO4, GPIO5, and GPIO13, GPIO14, GPIO15.
It looks like GND, VCC and backlight are ok - as the display is on!
If you are powering everything off the FTDI board it might not have enough current to power everything.
1 Attachment