load 0x40100000, len 1396, room 16 tail 4 chksum 0x89 load 0
$ÝabQbÁaL@$ÙabÁaLBERROR: Prompt not detected - upload failed. Trying to recover...
I keep getting these errors on nodemcu 0.9
tried esptool.py and nodemcu GIU, esptool flasher etc.
I was having similar, interesting problems with a HiLetgo NodeMCU board, and found it was a poor ground near the micro USB connector, such that if I just rested my fingertip there I could connect successfully (115200 baud), get a prompt, and interact normally with the board after removing my finger. It seems to be only on initial connection that there's this noise flakiness.
After getting in, I set up connecting the console via wifi (telnet), and connect that way without issue.
© Espruino, powered by microcosm.
Report a problem