You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Gordon
Ok, did you follow the steps at the top of this post? (Like checking to see if the tabs are all pushed in?)
If it's something else I'll send you out another display.
Just for the future though, it's probably best not to plug things in lots of different ways around unless you're sure it'll be ok. There are certain ways you could have plugged it in that could have damaged it.
Good point about the pins. It works for the starter kit, but some other types of breadboard don't have the numbers (and on some I bet the numbering is different!). It would probably help if I drew in lines for what is connected where, or it might make sense to do a proper top-down diagram.